Echo GT-225i User Manual download pdf (Page 24)

24 X7722273204

MAINTENANCE GT-225

Note: Every unit is run at the factory and the carburetor is set in compliance with emission regulations.

Carburetor adjustments, other than idle speed, must be performed by an authorized ECHO dealer.

1. Check idle speed and reset if necessary. If a tachometer is

available, idle speed screw (A) should be set to the

specifications found on “Specifications” page of this manual.

Turn idle screw (A) clockwise to increase idle speed; counter

clockwise to decrease idle speed.

When carburetor adjustment is completed, the cutting

attachment should not move at idle, otherwise serious

personal injury may result.

Lubrication

Level 1.

1. Remove plastic shield.

2. Loosen bearing housing locating screw (A), at the top of the

housing, loosen mounting screw (B) and remove gear case

from drive housing.

3. Pull the flexible drive shaft (C) from the drive housing, wipe

clean and recoat with a thin coating [1/2 oz. (15 ml)] of

grease.

4. Slide the flexible drive shaft back in the drive housing being

careful not to get dirt on the flexible drive shaft.

5. Install the bearing housing and shield.

Parts

Required:

POWER BLENDX

8 oz. or Lithium Base

Grease.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Echo GT-225i User Manual Page 24