Echo GT-225i User Manual download pdf (Page 11)

GT-225 DESCRIPTION

X7722273204 11

1. POWER HEAD - Factory Assembled to the Driveshaft assembly. Includes the Engine, Clutch, Fuel

System, Ignition System and Recoil Starter.

2. GRIP - Rear (right hand) handle.

3. STOP SWITCH - “SLIDE SWITCH” mounted on top of the Throttle Trigger Housing. Move switch

FORWARD to RUN, BACK to STOP.

4. FRONT HANDLE - The Front (loop) handle is factory assembled to the Drive Shaft assembly but must

be re-positioned for proper cutting attitude and operator comfort.

5. DRIVE SHAFT ASSEMBLY - Factory Assembled to the Power Head. Includes the Rear (right hand)

Handle Assembly, Bearing Housing Assembly, Throttle Trigger, Front (loop, left hand) Handle Assembly,

Flexible Drive Cable and Safety Decals.

6. RAPID LOADER

HEAD - Contains replaceable nylon trimming lines.

7. PLASTIC DEBRIS SHIELD ASSEMBLY - Included in plastic bag (co-pack). MUST be installed on unit

before use, see Assembly Instructions. Shield assembly includes the Cut-Off Knife. Mounts on the Gear

Housing Assembly just above the cutting attachment. Helps protect the operator by deflecting debris

produced during the trimming operation.

8. CUT-OFF KNIFE - Trims line to the correct length.

9. THROTTLE TRIGGER - Controls engine speed. Spring loaded to return to idle when released. During

acceleration, press trigger gradually for best operating technique.

10. TOP GUARD - Provides arm rest during operation and protects arm from hot engine.

11. SPARK ARRESTOR MUFFLER OR SPARK ARRESTOR MUFFLER WITH CATALYST - The muffler or

catalytic muffler controls exhaust noise and emission. The spark arrestor screen prevents hot, glowing

particles of carbon from leaving the muffler. Keep exhaust area clear of flammable debris.

12. FUEL TANK - Contains fuel and fuel filter..

13. RECOIL STARTER/HANDLE - Pull recoil starter handle/rope using light pulling force, approximately

2/3 (2 ft.) of rope length. Two (2) to Six (6) pulls are required to properly tension starter spring prior to

automatic engine engagement. DO NOT let handle snap back or damage to unit will occur.

14. FUEL TANK CAP - Covers and seals fuel tank opening.

15. PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging

air from the carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank return

line. Pump purge bulb an additional 4 or 5 times.

16. CHOKE - The choke control is located at the rear of the air cleaner housing. Move choke lever to Cold

Start ( ) to close choke for cold start. Move choke lever to “Run” ( ) position to open choke.

17. AIR CLEANER - Contains replaceable filter element.

18. SPARK PLUG - Provides spark to ignite fuel mixture.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Echo GT-225i User Manual Page 11