Echo GT-225i User Manual download pdf (Page 18)

18 X7722273204

OPERATION GT-225

Starting Warm Engine

The starting procedure is the same as Cold Start except DO

NOT close the choke, and do not hold throttle trigger fully

depressed.

The attachment should not move at idle, otherwise serious

personal injury may result.

Note: If attachment moves, readjust carburetor according to

“Carburetor Adjustment” instructions in this manual or

see your ECHO Dealer.

1. Stop Switch

Move stop switch button (A) away from the STOP position.

2. Purge Bulb

Pump purge bulb (C) until fuel is visible in the “Clear” fuel

return line. Pump bulb an additional 4 or 5 times.

Note: Energy is stored in the starter spring each time the

handle/rope is pulled. Generally two to six pulls, using

light pulling force, will store enough energy to engage the

starter and spin the engine. Do not pull the rope out to

end stop.

3. Recoil Starter

Lay the unit on a flat area and keep movable attachment parts

clear of all obstacles. Gently pull recoil starter handle/rope (D)

until engine fires.

Note: If engine does not start after 2-3 engine engagements,

use Cold Start Procedure.

Stopping Engine

1. Throttle

Release throttle and allow engine to return to idle before

shutting off engine.

2. Stop Switch

Move stop switch button(A) backward to STOP position.

If engine does not stop when stop switch is moved to STOP

position, close choke - COLD START position - to stall engine. Have your ECHO dealer repair stop

switch before using trimmer again.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

No comments

Echo GT-225i User Manual Page 18