Echo 72825 Instruction User Manual

Browse online or download User Manual for Gardening equipment Echo 72825 Instruction. Echo 72825 Instruction User Manual [en]

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Instruction Sheet
Instructions
SUBJECT: Electronic Feed Kit
(PN 73244)
FITS MODELS: CH6614H (72620),
74824, 72825, CH911DH (72928),
72942, CH922DH (74950)
PN 73243
Rev. 022608
MOUNTING THE LOFA CONTROL
Remove upper belt guard. 1.
Remove the top cover from the Feed Roller Support 2.
unit. If the serial number is equal to or greater than
X01249, skip to STEP 6 (Figure 1).
Remove the back cover from the LOFA control, center it 3.
3-1/2” from the top on the front plate of the Feed Roller
Support housing and mark the position of the holes.
Drill four 1/4” holes (Figure 1).4.
Attach the ISO-Mounts to the controller back plate with 5.
the bolts and nuts provided (Figure 2).
Secure the back plate of the controller to the Feed 6.
Roller Support housing with a washer and one M4-0.7
nuts per bolt, apply locking adhesive and tighten.
Replace the Feed Roller Support cover.7.
Attach the LOFA Control to the back plate (Figure 2)8. .
Figure 2
Figure 1
TOP COVER
FOUR 1/4" HOLES
BEFORE INSPECTING OR SERVICING ANY PART
OF THIS MACHINE, SHUT OFF POWER SOURCE,
DISCONNECT SPARK PLUG WIRE FROM SPARK
PLUG AND MAKE SURE ALL MOVING PARTS HAVE
COME TO A COMPLETE STOP.
WARNING
Page view 0
1 2 3 4

Summary of Contents

Page 1 - Instructions

Instruction SheetInstructionsSUBJECT: Electronic Feed Kit (PN 73244)FITS MODELS: CH6614H (72620), 74824, 72825, CH911DH (72928), 72942, CH922DH

Page 2 - POSITIONING THE SENSOR

Instruction SheetINSTALLING THE SOLENOID CARTRIDGE VALVEModel 76824 requires the installation of a cross over valve and hoses. Cross over valve (128

Page 3 - WIRING SCHEMATIC

Instruction SheetMODELS: CH911DH (72928), 72942 & CH922DH (74950)Crimp a ring terminal onto the Black, Ground lead.1. Drill a 3/16” hole in

Page 4 - INSTRUCTIONS

Instruction Sheet FEED SENSOR PROGRAMMING INSTRUCTIONSSTEP 1. INITIATING PROGRAM MODEHold down the “S” button while turning the engine key to the “

Comments to this Manuals

No comments