Echo SRM-2400SB User Manual download pdf (Page 11)

Power edger AttAchment

oPerAtor's mAnuAl

5. Clean all loose debris from gear box.

6. Remove plug (G) and check level of grease. Grease should ll gear

case to bottom of grease plug hole.

7. Add grease if necessary using manual grease gun or squeeze-type

tube. Do not use high pressure grease gun. DO NOT over-ll.

8. Install inner blade adapter (B) onto PTO shaft (C).

9. Install and center new blade (F) onto inner adapter (B).

10. Install outer adapter (E) and nut (D). Tighten nut (D) rmly,

counterclockwise (CCW).

IMPORTANT

Never reuse old split pin.

11. Install new split pin (A) to secure nut.

Drive Shaft (Lower)

1. Loosen two (2) screws (A) and remove center locating screw (B).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable (C) from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the exible cable (C) back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Echo SRM-2400SB User Manual Page 11