Echo Chain Saw CS-400 User Manual download pdf (Page 16)

CS-400

Open choke

Choke control knob

WHEN THE ENGINE IS WARM

• Move chain brake lever fully forward to lock chain

brake before starting.

• Conrm there is fuel and chain oil in the tanks.

• Move ignition switch to “RUN” position.

• Securely hold the chain saw as shown and pull

starter handle.

• Choke may be used if necessary, but be sure to push

it back on rst ring sound.

NOTE

If engine does not start after 5 pulls, use cold start

procedure.

Lock Chain

brake

Starter handle

CS-400

Oil tank capFuel tank cap

Cap indication

Fuel/oil tanks are indicated by the following

illustrations.

CHAIN LUBRICANT

Proper lubrication of the chain while in operation

reduces friction between the chain and the guide

bar to a minimum and assures a longer service life.

• Use bar and chain oil of high quality for this

purpose.

• Do not use used or reclaimed oil to avoid various

oiler problems.

• Use ECHO bar and chain oil.

• When ECHO bar and chain oil is not available:

Use motor oil, etc.

• Use bar and chain oil of the following grades:

SAE No. 30 .......in summer

SAE No. 10 .......in winter or when cutting

resinous trees.

• When refueling, also refill chain oil.

OPERATION

WARNING

• After choke control knob is pulled and then

knob is returned to original position,

throttle remains a little open (latch

condition).

• If engine is started in this latch condition,

chain starts to turn. Do not start engine

before chain brake is activated.

CAUTION

• After starting the engine, squeeze throttle

trigger slightly to release throttle latch and

pull front hand guard towards the operator

immediately.

(Chain brake unlocked position)

• Never use throttle latch for cutting.

• Use the chain brake only in starting or in

emergencies.

Start / Run

Ignition switch

Chain brake

Starter handle

Unlock chain brake

Choke

Choke control knob

Purge pump

• Securely hold the chain saw as shown and pull

starter handle several times until rst ring sound.

• Push choke control knob all the way in.

• Pull starter handle to start the engine.

NOTE

If engine does not start after 5 pulls, repeat instruc-

tions.

• When engine starts, immediately squeeze throttle trig-

ger to release the latch, otherwise damage to clutch

may result.

Open choke

Choke control knob

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Echo Chain Saw CS-400 User Manual Page 16

Comments to this Manuals

Related products and manuals for Petrol tool Echo Chain Saw CS-400