
Shaft Hedge Clipper AttachmentOperator's Manual MODEL 99944200485 MODELS USED ON: SRM-2100SB SRM-2400SB SRM-210SB/211SB/225SB
101. Hold trimmer rmly and squeeze throttle trigger to accelerate engine.2. Tilt trimmer so cutting teeth are angled slightly toward the hedge or s
Shaft hedge Clipper attaChmentOperatOr'S manual 11lubrICaTIonBlades Level 1Parts Required: 20W Engine Oil (lubrication), 50-50 mixture of
12Drive Shaft AssemblyLevel 1.Parts required: POWER BLENDXTM 8 oz. or Lithium Based Grease. WARNINGHedge Clipper blades are very shar
Shaft hedge Clipper attaChmentOperatOr'S manual 131. Move stop switch to stop position.2. Disconnect spark plug wire.3. Slide blades to allow
14Ablade adjusTmenTLevel 2.1. Move stop switch to STOP position.2. Disconnect spark plug wire. WARNING Hedge clipper blades are very sharp. Touc
Shaft hedge Clipper attaChmentOperatOr'S manual 15sTorageIMPORTANTAlways install blade cover when transporting or storing unit. 1. Clean and lu
16warranTy sTaTemenTsECHO LIMITED WARRANTY STATEMENT FOR PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010ECHO'S RESPONSIBILITYECHO Incorporate
Shaft hedge Clipper attaChmentOperatOr'S manual 17PURCHASED REPAIR PARTS, SHORT BLOCKS AND ACCESSORIES
18noTes
Shaft hedge Clipper attaChmentOperatOr'S manual 19noTes
2Copyright© 2013 By Echo, IncorporatedAll Rights Reserved.Table of ConTenTsIntroduction ...
DEALER?Call1-800-432-ECHOorwww.echo-usa.comCONSUMER PRODUCTSUPPORT1-800-673-15588:30 - 4:30 Mon - Fri C.S.T.eCho, InCorporaTed400 oakwood roadlake Zur
Shaft hedge Clipper attaChmentOperatOr'S manual 3 WARNING Refer to your Pro Attachment Series or Split Boom Operator's Manual for correct e
4Physical ConditionYour judgment and physical dexterity may not be good: • if you are tired or sick,
Shaft hedge Clipper attaChmentOperatOr'S manual 5Repetitive Stress Injuries It is believed that overusing the muscles and tendons of the ngers,
6equIpmenT WARNINGUse this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined with a non ap
Shaft hedge Clipper attaChmentOperatOr'S manual 71desCrIpTIonLocate this safety decal on your attachment. Make sure the decal is legible and tha
8Parts Required: PAS or SRM-SB Power Head w/Shaft & Coupling.1. Set Power Head/Shaft Assembly on a level surface.2. Pull locator pin (A) out, a
Shaft hedge Clipper attaChmentOperatOr'S manual 9fronT loop handle removalParts Required: NoneNOTEFront loop handles/loop handles with barrier b
Comments to this Manuals