Echo CS-271T User Manual download pdf (Page 12)

10

CS-271T

PREPARATION FOR USE

WARNING

Saw chain is sharp! Always wear gloves

when handling assembly, otherwise serious

personal injury may result.

KICK GUARD

®

TO BAR

INSTRUCTIONS

Tools Needed: Two 11 mm (7/16 in.) Wrenches.

For saws with Kick Guard

®

P/N 2893201 and

Symmetrical Low-Kick type (Double Guard)

guide bars.

1. Install bolt (A) in

rear

hole (B) of Kick Guard

®

and through front hole (C) in guide bar.

2. IMPORTANT: Dimple (D) in Kick Guard

®

must

engage recess (E) in guide bar.

3. Tighten nut (F) and bolt (A) using 11 mm (7/16

in.) wrenches until snug. Make certain Kick

Guard

®

is flush against guide bar.

4. Tighten nut (F) 1/8 additional turn.

5. Check to make certain Kick Guard

®

is tight on

guide bar.

GUIDE BAR AND SAW CHAIN

INSTALLATION/REMOVAL

NOTICE

• Move the chain brake lever (Front hand guard)

fully rearward to remove or install the clutch

cover to chain saw.

1. Remove spark plug lead. (See page 25)

2. Remove the clutch cover nut and remove clutch

cover.

3. Remove bar and saw chain if necessary. See

“Maintenance and Care” section for guide bar/

saw chain maintenance procedures.

Bolt (A)

Dimple (D)

Recess (E)

Front hole (C)

Rear

hole (B)

Nut (F)

Guide bar

Kick Guard

®

Clutch cover

Brake lever

(Front hand guard)

A nut

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Comments to this Manuals

No comments