Echo SRM - 230S User Manual download pdf (Page 16)

OPERATION

STARTING

COLD ENGINE

WARNING DANGER

The attachment will operate immediately when the engine starts and

could result in loss of control and possible serious injury. Keep

movable parts of the attachment off the ground and away from

objects that could become entangled or thrown.

1. Stop Switch

Move stop switch button (A) forward away from the STOP

position.

2. Choke

Move choke lever (B) to Cold Start Position ( ).

3. Primer

Pump primer bulb (C) until fuel is visible and flows freely in the

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4. Recoil Starter

Lay the unit on a flat area and keep movable attachment parts clear

of all obstacles. Firmly grasp right hand grip and throttle trigger

lockout with left hand and fully depress throttle trigger to wide

open position. Rapidly pull recoil starter handle/rope (D) until

engine fires (or maximum five [5] pulls).

5. Choke

After engine fires (or 5 pulls), move choke lever back to Run ( )

position. Hold throttle trigger and throttle trigger lockout fully

depressed, and pull recoil starter starter handle/rope until engine

starts and runs. Release throttle trigger, and allow unit to warm up

at idle for several minutes.

NOTE

If engine does not start with choke in “Run” position after 5 pulls,

repeat instructions 4 and 5.

6. Throttle Trigger

After engine warm-up, gradually depress throttle trigger to increase

engine RPM to operating speed.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

No comments

Echo SRM - 230S User Manual Page 16