Echo SRM - 230S User Manual download pdf (Page 24)

l u b r I c a t I o n

Level 1.

Tools Required: 13 mm Open End Wrench, Screwdriver, Clean Rag.

Parts Required: POWER BLENDX

8 oz. (P/N 91014) or Lithium

Base Grease.

Gear Housing

1. Clean all loose debris from gear box.

2. Remove plug (A) and check level of grease.

3. Add grease if necessary, DO NOT over ll.

Drive Shaft

(SRM-230 Only)

1. Loosen two (2) screws (B) and remove center locating screw (C).

Pull gear box and shield from drive shaft housing.

2. Pull exible cable from the drive shaft housing, wipe clean and

re-coat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the exible cable back in the drive housing. DO NOT get

dirt on the ex cable.

4. Install the gear housing and shield assembly.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

(SRM-230S Only)

No Lubrication Needed.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

Echo SRM - 230S User Manual Page 24