Echo PB-250LN User Manual download pdf (Page 16)

16 X7501183303

OPERATION PB-250LN

4. Purge Bulb

Pump purge bulb (D) until fuel is visible and flows freely in the

clear fuel tank return line.

Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for

starting. Do not allow the rope to snap back in. Always hold the

unit firmly.

5. Recoil Starter

Place the unit on a flat, clear area. Firmly grasp throttle grip

with left hand and rapidly pull recoil starter handle/rope (E)

until engine fires , or maximum 5 pulls.

6. Choke

Move choke lever (C) to Run position, and if necessary,

restart engine.

Note: If engine does not start with choke in “Run” position after

5 pulls, repeat instructions 3 - 6.

7. Throttle Trigger

After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.

Note: Allow engine to warm up 3 minutes before use.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO

NOT close the choke.

1. Stop Switch

Move stop switch (A) away from the STOP position.

2. Throttle Position Lever

Move throttle position lever (B) midway between idle and full

throttle positions.

3. Purge Bulb

Pump purge bulb (D) until fuel is visible and flows freely in the

clear fuel tank return line.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

No comments

Echo PB-250LN User Manual Page 16