Echo 99944200553 User Manual Page 1

ProSweep AttachmentModel 99944200553Operator's ManualFOR MODELS: SRM-2400SB SRM-260SB/261SB PAS-2400 PAS-230/231 PAS-260/261 PAS-

101. Hold unit on your right side resting sweeper brushes on work sur-face.2. Firmly grasp throttle grip with right hand and front handle with left

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l11 WARNING Always stop engine and disconnect spark plug before performing maintena

12Drive ShaftIMPORTANTLower and upper drive shaft must be lubricated with POWER BLENDXTM grease every 25 hours of operation, otherwise drive shaft ass

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l13b r u s h r e p l a c e m e n tLevel 1.Tools Required: 8 mm Open End Wrench, C

14st o r a g e1. Clean ProSweep attachment bristles with water. IMPORTANTDo not immerse this attachment in water. Water will enter gear housing and d

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l15n o t e

se r v I c I n g In f o r m a t I o np a r t s/s e r I a l n u m b e r Genuine ECHO Parts and ECHO REPOWER™ Parts and Assem-blies for your ECHO pro

2Copyright© 2009 By Echo, IncorporatedAll Rights Reserved.In t r o d u c t I o nWelcome to the ECHO family. This ECHO product was designed and manufac

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l3sa f e t ym a n u a l s a f e t y s y m b o l s a n d I m p o r t a n t I n f o

4Physical ConditionYour judgment and physical dexterity may not be good: • if you are sick, • if you

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l5Repetitive Stress Injuries --It is believed that overusing the muscles and tendons

6e q u I p m e n t WARNING Use this attachment with ECHO approved models only. Serious injury may result from the use of this attachment combined wi

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l712341. BRUSHES - Permanently attached to drum holders and come standard with 0.5 m

8as s e m b l y WARNING Do not perform maintenance or assembly procdures with engine running.Tools Required: 4 & 5 mm Hex WrenchParts Required:

Pr o Sw e e P At t A c h m e n toP e r A t o r 'S mA n u A l91. Turn gear housing assembly over so that gear housing mounting bolt (E) faces up